CLIA Kit for Nitric Oxide Synthase 1, Neuronal (NOS1)
Cat# USCN-SCA815Hu-96
Size : 96T
Brand : USCN
CLIA Kit for Nitric Oxide Synthase 1, Neuronal (NOS1)
NOS; nNOS; IHPS1; NC-NOS; N-NOS; bNOS; Neuronal NOS; Constitutive NOS; NOS type I; Nitric Ocide Synthase; Peptidyl-cysteine S-nitrosylase NOS1
- Product No.SCA815Hu
- Organism SpeciesHomo sapiens (Human) Same name, Different species.
- Test MethodDouble-antibody Sandwich
- Assay Length2h, 40min
- Detection Range13.7-10,000pg/mL
- SensitivityThe minimum detectable dose of this kit is typically less than 6.3pg/mL.
- Sample TypeSerum, plasma, tissue homogenates and other biological fluids
- Download Instruction Manual
- UOM 48T96T 96T*5 96T*10 96T*100
-
Packages (Simulation) -
Packages (Simulation)
-
Results demonstration
-
ISO9001: 2008, ISO13485: 2003 Registered
Specificity of the CLIA Kit for Nitric Oxide Synthase 1, Neuronal (NOS1)
This assay has high sensitivity and excellent specificity for detection of Nitric Oxide Synthase 1, Neuronal (NOS1).
No significant cross-reactivity or interference between Nitric Oxide Synthase 1, Neuronal (NOS1) and analogues was observed.
Recovery of the CLIA Kit for Nitric Oxide Synthase 1, Neuronal (NOS1)
Matrices listed below were spiked with certain level of recombinant Nitric Oxide Synthase 1, Neuronal (NOS1) and the recovery rates were calculated by comparing the measured value to the expected amount of Nitric Oxide Synthase 1, Neuronal (NOS1) in samples.
| Matrix | Recovery range (%) | Average(%) |
| serum(n=5) | 95-105 | 99 |
| EDTA plasma(n=5) | 95-103 | 99 |
| heparin plasma(n=5) | 93-101 | 97 |
Precision of the CLIA Kit for Nitric Oxide Synthase 1, Neuronal (NOS1)
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Nitric Oxide Synthase 1, Neuronal (NOS1) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Nitric Oxide Synthase 1, Neuronal (NOS1) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%
Linearity of the CLIA Kit for Nitric Oxide Synthase 1, Neuronal (NOS1)
The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Nitric Oxide Synthase 1, Neuronal (NOS1) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.
| Sample | 1:2 | 1:4 | 1:8 | 1:16 |
| serum(n=5) | 94-103% | 97-104% | 96-105% | 78-93% |
| EDTA plasma(n=5) | 98-105% | 94-103% | 99-105% | 78-96% |
| heparin plasma(n=5) | 90-104% | 81-104% | 88-102% | 80-97% |
Stability of the CLIA Kit for Nitric Oxide Synthase 1, Neuronal (NOS1)
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
Assay procedure summary of the CLIA Kit for Nitric Oxide Synthase 1, Neuronal (NOS1)
1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 100µL Substrate Solution. Incubate 10 minutes at 37°C;
8. Read RLU value immediately.
Test principle of the CLIA Kit for Nitric Oxide Synthase 1, Neuronal (NOS1)
The microplate provided in this kit has been pre-coated with an antibody specific to Nitric Oxide Synthase 1, Neuronal (NOS1). Standards or samples are then added to the appropriate microplate wells with a biotin-conjugated antibody specific to Nitric Oxide Synthase 1, Neuronal (NOS1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. Then the mixture of substrate A and B is added to generate glow light emission kinetics. Upon plate development, the intensity of the emitted light is proportional to the Nitric Oxide Synthase 1, Neuronal (NOS1) level in the sample or standard.;